Development of a Simple Impulse Turbine for Nano Hydropower (2009)
Nakanishi, Y, Iio, S, Takahashi, Y, Kato, A, Ikeda, T
The aim of this work is to provide an impulse type hydraulic turbine to utilize unexploited water resources as nano hydropower in the mountainous area. The turbine is simplified to make cheap energy...
Iio, S, Haneda, Y, Matsubara, Y, Ikeda, T
The experimental study of flow field and heat transfer characteristics of a submerged, rectangular jet impinging normally on a flat plate is presented. Four nozzle-to-surface spacing of H/w=3, 6, 10...
Development of net-current free heliotron plasmas in the Large Helical Device (2009)
Komori, A., Yamada, H., Sakakibara, S., Kaneko, O., Kawahata, K., Mutoh, T., ...
Performance of Savonius Rotor for Environmentally Friendly Hydraulic Turbine (2008)
The aim of this investigation was to develop an environmentally friendly nano-hydraulic turbine. A model of a two-bucket Savonius type hydraulic turbine was constructed and tested in a water tunnel...
Performance of Double-step Savonius Rotor for Environmentally Friendly Hydraulic Turbine (2008)
The aim of this investigation is to develop an environmentally friendly nano-hydraulic turbine. Three type models of Savonius rotor are constructed and tested in a water tunnel to improve and clarify...
Acoustic Control of an Impinging Planar Jet upon a Wedge (2008)
Iio, S, Hibino, K, Matsubara, M, Ikeda, T
Active control of an impinging jet upon a wedge has been attempted using a sinusoidal excitation of blowing and sucking at the jet exit. The excitation sufficiently enables 'phase-lock', which is...
Numerical analysis of control of flow oscillations in open cavity using moving bottom wall (2006)
Yoshida, T, Watanabe, T, Ikeda, T, Iio, S
(c)copyright 2006.The Japan Society of Mechanical Engineers
Effect of silane-coupling agent on natural rubber filled with silica generated in situ (2003)
Murakami, K, Iio, S, Ikeda, Y, Ito, H, Tosaka, M, Kohjiya, S
Mo-Mn Metallization on AlN Substrate. (1998)
Nozaki, S., Kanda, A., Iio, S., Nakayama, Y., Kato, N.
Mo-Mn post fire metallization, which has been widely used on alumina substrates to make a electro-conductive layer for electronic devices, was applied to AlN substrates. Metallization on AlN...
Itoh, H., Sugimoto, H., Iwahara, H., Otsuka, J., Iio, S.
Alumina powders (average grain size: 50 micron) coated with TiN film of thickness 0.5 and 1.2 micron were prepared by rotary powder-bed chemical vapor deposition for 15 and 90 min, respectively....