Growth Performance of Cyprinus carpio L. in Intensively Different Organic Manures (2009)
Chakrabarty, D., Das, M. K., Das, S. K.
Qualitative and quantitative analyses of phyto- and zooplankton, and growth performance of Cyprinus carpio Linnaeus were done in earthen vats receiving compost, Diammonium Phosphate and vermicompost...
Comparison of Intact Rock Failure Criteria using Various Statistical Methods (2009)
This paper describes comparison of four different rock failure criteria based on triaxial test data of ten different rock strength data using various statistical methods. Least square, least median...
Venkateswarlu, K, Rajinikanth, V, Sirkar, M K, Sinha, Dhiraj Prasad, Das, S K
In the present investigation, high stress abrasive wear behavior of the liner materials commonly used in coal fired thermal power plants was simulated by performing two body abrasion tests on...
Ravi Kumar, B, Das, S K, Mahato, B, Das, Arpan
Austenitic stainless steel of 304L type was thermo-mechanically processed to enhance special low CSL boundaries. Rolling reductions of above 60% of thickness was employed prior to annealing. It was...
Characterization of rupture and fatigue resistance of TBC superalloy for combustion liners (2005)
Ray, Ajoy K, Das, D K, Venkataraman, B, Roy , P K, Goswami, B, Roy, Nilima, ...
High-temperature, high-cycle fatigue and accelerated creep properties of thermal barrier coated (TBC) Superni C263 alloy used as a candidate material in combustor liners of aero engines are...
Das, S K, Joarder, A, Mitra, A
Low alloy steel such as 1.25Cr–0.50 Mo steel is widely used in thermal power plants, petro-chemical industries and fertiliser plants. In recent years considerable attention has been paid to...
Phosphate induced stress corrosion cracking in a waterwall tube from a coal fired boiler (2003)
Srikanth, S, Gopalakrishna, K, Das, S K, Ravi Kumar, B
The failure of a waterwall tube in a coal-fired boiler from a thermal power station was analyzed. Mild whitish deposit formation in the water-side of the tube with multiple fine cracks on the...
Ray, Ajoy K, Venkateswarlu, K, Chaudhury, S K, Das, S K, Ravi Kumar, B, Pathak, L C
Fabrication of Al–TiN (10, 30 wt.%) composites by a powder metallurgical route has been investigated using pressureless sintering and hot pressing techniques. Results indicate that sintering...